GENERAL FEATURES
IP Protection grade - IP68
Installation on -  Hull
Dimensions - Ø 130X200 mm
Mounting hole - Ø 16 mm
Fixing system - screws
----------------------------------
MATERIALS
BODY - SYNTHETIC MATERIAL STAINLESS STEEL AISI 316L
INTERIOR - RESIN
DIFFUSER - TEMPERATED GLASS
Orientable - No
Flexible - No
Switch - No
-------------------------
ELECTRICAL SPECIFICATIONS
Type of power Constant Voltage
Light source 64 high luminosity led
Light Type One Color
Power supply 79 W
Power consumption 10,5 - 30 Vd
Absorption 2A@12V / 1@24V
Dimmable / Recommended dimmer No
-----------------------
PHOTOMETRIC DATA
Color Temperature cold white (5500 - 6500°K)
Luminous flux typical 10000 lm
Luminous efficacy 125 lm/L
Available light colours mix
----------------------
SPECIFICATION FOR THE CONNECTION OF INDIVIDUAL UNIT
Power 79 W
Power Supply 100 / 240 V

---------------------
CONNECTION INFORMATIONS 
WARNINGS Use your own supplied power supply. Do not connect the appliance directly to the mains (AC).
This product can be connected in parallel.
----------------------
INSTRUCTIONS FOR ASSEMBLY
1- Drill a Ø 6 mm hole through the hull where the light’s centerposition will be.
2- Apply marine grade sealant liberally to the stem and the back perimeter of the light body (as shown in the diagram), as well as around the screw
holes.
3 - Insert the light body into the hull, feeding the stem through first. Press the light into the hull and twist slightly to spread the sealant
around evenly behind the light, and then attach the light with fasteners suitable for the type of hull.
4- WARNING: The lamp should be wired to a zinc hull anode with anelectrical cable.
5 - Paint the metallic frame of the light with a compatible antifouling paint.
6 - Complete the electrical installation by following the wiring diagram.
7 - In case of any doubts, contact the dealer or MAIBAKLED.
8 - Before installing on steel or aluminum boat hulls (in order to avoid galvanic corrosion), contact the dealer or MAIBAKLED.
9-  Before installing on a cored fiberglass hull, contact the dealer or MAIBAKLED.
1O - To prevent the LED lights from overheating, do not leave the lights on for more than one minute when they are not submerged in water.
(The lights should only be turned on for testing purposes).